Laser Cutting Projects – Day 6

I’m into the lamp swing. Today I made a variation of the lamp from day 3. That lamp had 16 slats that were all the same. I made this one a little larger so I can actually replace the light bulb, increased the number of slats to 18, and changed the slats so that they are each different – giving it an asymmetrical form.

I also stained the wood using an oak stain and then put an acrylic coat on it before I cut out the pieces.

lamp_4_1 lamp_4_2

Material Costs

  • $12 – one and a half sheets of plywood
  • $10 – lamp kit
  • $10 – bulb

Total material costs $22


  • 1 hours non-recurring
  • 60 minutes recurring
Total Views: 1205 ,

Leave a Reply